Everything below concerns Reversed-phase HPLC. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-02-11. Numbers and descriptions here follow the published literature rather than marketing material.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Interest in epitalon is usually discussed within the broader field of short peptide bioregulators, a category that includes other synthetic di-, tri-, and tetrapeptides studied by the same research group. These compounds share a common rationale: that small fragments of tissue-derived proteins can retain biological activity and can be produced reproducibly. The category as a whole remains outside mainstream pharmacological consensus, and epitalon specifically has a limited presence in independent, non-Russian research literature, which shapes how its evidence base is described.
Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection, frequently near 214 nanometers where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the observed molecular mass and helps separate the intact peptide from truncated or modified forms. Amino acid analysis or tandem mass spectrometry can establish residue order. Purity is commonly quoted as an area percentage, yet such values are method-dependent, and comparisons between laboratories require matching column, gradient and detection wavelength.
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
== Technologies == Camurus is a company focused on the development of lipid lyotropic liquid crystal structures for pharmaceutical drug delivery applications. These structures are well-defined three-dimensional formations consisting of lipophilic and hydrophilic domains that can be either interconnected or isolated depending on the environmentally induced phase conditions. The unique crystalline structures offer a unique way of encapsulating and transporting Active pharmaceutical ingredients, such as small molecules, peptides and proteins through the body. The structures also allow for the use of controlled release and prevention of degradation of fragile short half live molecules, a serious issue for amino-acid based drugs.
=== FluidCrystal technology === Camurus' FluidCrystal are available as injectable depots and topical bioadhesive delivery technologies. By encapsulating the drug compound in the nanostructures, injectable depots are able to deliver therapeutic levels of drug substance over extended periods from a single injection. This leads to a decrease in traditional side effects associated with high initial drug release on injection (drug burst), poor drug stability, and complex processing requirements, making the system highly suitable for sustained parental delivery of peptides, proteins, and small molecule drug compounds. The topical delivery system creates a bio-adhesive film that provides local and continual release of drug compounds. The delivery system is suited for delivery of peptide, protein, and small molecule drug compounds and can be applied to dermal, buccal, ophthalmic, nasal, vaginal, and other topical surfaces.
=== Elyzol dental gel - parodontitis === Camurus has partnered with Colgate-Palmolive for the marketing of their Elyzol dental gel for the treatment of parodontitis. Elyzol 25% dental gel contains metronidazole in the form of metronidazole benzoate as the active substance.
Sources: en.wikipedia.org
=== Episil - oral mucositis pain === Oral mucositis is a severe side-effect of chemotherapy or radiotherapy during cancer treatment, and is often a dose-limiting factor in treatment. episil is administered as a lipid-based liquid that spreads on the intra-oral mucosal surfaces and transforms to a strongly bioadhesive FluidCrystal film that mechanically protects the sensitized and sore epithelium of the oral cavity. It has been demonstrated in several clinical trials that episil gives an immediate and significant reduction of pain. This analgesic effect was maintained over at least 8 hours following administration. The treatment was reported to be safe and well tolerated. The product is registered as a medical device in a wide range of countries, including the European Union and the United States.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.